Parkside 361688_2010, Instructions Manual

Page: 8 / 97

PLSA 20-Li A1 ■ 4
│
GB
│
IE
Before use
Changing the soldering tip
CAUTION! RISK OF BURNS!
► Never heat the soldering iron
1
without a
soldering tip
q
.
■ Removing the soldering tip
q
may only be
carried out when the appliance is switched off
and the soldering tip
q
has cooled down.
♦ Loosen the retaining nut
9
completely and
remove it.
♦ Pull the fixing sleeve
0
off the soldering
iron
1
.
♦ Change the soldering tip
q
.
♦ Proceed in the reverse order to reassemble
the soldering iron
1
.
Inserting the battery
♦ Push the charged battery
5
into the soldering
station.
It clicks into place audibly.
Use
Switching on/off
Switching on
♦ Press the ON/OFF switch
6
.
The status LED
7
flashes red
rapidly. The soldering iron
1
heats up.
♦ As soon as the status LED
7
lights
up green, the soldering iron
1
is
ready for use.
NOTE
► After 10 minutes, the appliance switches off
automatically and reverts to cooling mode.
Press the ON/OFF switch
6
again to reheat
the appliance.
► Before using the soldering station for the first
time and before using a new soldering tip, the
soldering tip
q
must first be tinned.
Switching off
NOTE
► After use, always put the soldering iron
1
back into the holder for the soldering iron
3
.
♦ Press the ON/OFF switch
6
again. The status LED
7
flashes
red slowly for around 10 minutes.
This is the cool-down mode and is intended to
warn the user that the soldering iron
1
is still
dangerously hot.
NOTE
► After the status LED
7
has gone out, leave
the soldering iron
1
in the holder for the
soldering iron
3
for at least 30 minutes to
cool down.
♦ When the appliance is not in use, remove the
battery
5
. To do so, press and hold down the
release button
8
.