Parkside 356347 2004, Original Instructions Manual

Page: 33 / 125

PHKSA 20-Li A2 GB
│
IE
│
29 ■
Rip fence
♦ Undo the wing screw and insert the rip
fence into the rip fence slot .
♦ Set the desired cut width with the help of the
scale on the rip fence and the cut out in the
base plate (see also fig. B).
The right recess in the base plate is for a cutting
angle of 0°. The left-hand recess in the base
plate is for a cutting angle of 45°.
ATTENTION!
♦ Adjust the rip fence so that it can never
come into contact with the blade guard or
the saw blade !
Fig. B: Cutting width 3 cm
♦ Retighten the wing screw .
Connecting the sawdust extraction
device
♦ Attach the adapter for dust extraction to the
chip ejector .
Optional, depending on the diameter of the
dust and sawdust extraction.
♦ Connect an approved dust and chip extraction
device.
NOTE
► When sawing wood or other materials that
create dusts that are hazardous to health,
always connect the appliance to a suitable,
certified suction appliance.
Use
Switching on and off
Switching on
♦ Push the safety lock-out to the left or right
and keep it pressed.
♦ Press the ON/OFF switch . Once the saw is
running, you can release the safety lock-out .
Switching off
♦ Release the ON/OFF switch .
Setting the cutting angle
You can select the cutting angle using the cutting
angle scale .
■ Undo the wing screw of the cutting angle pre-
selector , set the desired cutting angle on the
cutting angle scale and then retighten the
wing screw .
Setting the cutting depth
NOTE
► Select a cutting depth of approx. 3 mm more
than the thickness of the material. This ensures
that you achieve a clean cut.
♦ Undo the locking screw , set the desired
cutting depth on the cutting depth scale and
then retighten the locking screw .
Working with the circular saw
1. Switch on the appliance – as described in
"Switching on and off" – and then place it with
the front edge of the base plate on the
material.
2. Align the machine using the rip fence or by
using a marked line.
3. Hold the machine in both hands using the
handles and saw by exerting an even pressure.
IB_356347_PHKSA20-LiA2_LB8.indb 29 20.10.20 13:00