Parkside 346166 2004, Original Instructions Manual

Page: 54 / 75

PAT 20-Li A1 ■ 50
│
GB
│
MT
Filling the magazine shaft
Remove the battery before carrying out any
work on the power tool (e.g. maintenance,
changing tools, etc.) as well as during the
transport and storage of the power tool.
Unintentional activation of the trigger can result in
injury.
♦ Remove the battery pack from the appliance.
♦ Turn the appliance around.
♦ Press the release together (see fig. B).
♦ Pull the magazine slider backwards
(see fig. B).
♦ Fill the magazine shaft with staples or nails
(see fig. C).
NOTE
► Ensure the correct position for the nails (see
main diagram, face plate on the appli-
ance).
♦ After filling, push the release into the maga-
zine shaft as far as the stop until it clicks into
place.
NOTE
► The fill level indicator shows whether the
magazine contains staples.
Setting the impact force
NOTE
► Select the lowest impact force sufficient for
stapling. Take into account the length of the
staples or nails you are using as well as
hardness of the material you are working
with.
Increasing the impact force
♦ Turn the impact force control clockwise.
Reducing the impact force
♦ Turn the impact force control anticlockwise.
Operation
Switch on
♦ Press the tacker nose onto the location on
the material that you want to staple until it is
pushed in a few millimetres.
♦ Press the trigger .
Switching on the LED work light
♦ Press the button for the LED work light to
illuminate your workspace in unfavourable
lighting conditions.
Troubleshooting
Cause
A staple is blocking the appliance.
Solution
♦ Remove the battery pack from the appliance.
♦ Turn the appliance around.
♦ Press the release together (see fig. B).
♦ Pull the magazine slider backwards
(see fig. B). This will release the tension.
♦ Remove the staple.
WARNING!
■ Do not hold the power tool by the trigger
if the staple is jammed in the power tool.
While removing a jammed staple, the
trigger can be accidentally activated.