Parkside 339645 1910, Translation Of The Original Instructions

Page: 9 / 24

PEXS 270 C3 ■ 6 │
GB
│
IE
│
NI
Before use
Selecting a sanding sheet
Removal and surface
The material removal rate and surface quality are
determined by the grain strength of the sanding
sheet .
■ Please note that you need to use sandpapers
with different grains for working different
materials .
Changing sanding sheets
The random orbital sander has a Velcro sheet that
enables fast and simple changing of the sanding
sheets .
♦ Life the sanding sheet
4
on one side and pull
it off the sanding pad
3
to remove it .
NOTE
► Before fitting a new sanding sheet
4
, remove
any dust and dirt from the sanding pad
3
.
♦ Make sure that the holes on the sanding sheet
4
match up with the holes on the sanding pad
3
.
Dust/chip extraction
■ Please refer to the section entitled "Safety
information" .
Dust extraction unit with dust collecting
device
♦ Push the dust collector
2
fully onto the appliance .
♦ To empty the dust collector
2
, pull it off the
appliance .
NOTE
► To ensure optimum extraction, empty the
dust collector
2
regularly and tap it out .
To do this, open the dust collector
2
by
pressing on the catch
8
and pulling off
the rear part . Now remove the dust bag .
External extraction
Connecting
♦ To remove dust using a vacuum cleaner, push
the suction hose of a suitable dust extraction
device (e .g . a workshop vacuum cleaner) onto
the exhaust nozzle
6
.
NOTE
► If necessary, use the adapter
7
by pushing it
into the exhaust nozzle
6
.
Removal
♦ Pull the hose of the vacuum cleaner off the
exhaust nozzle
6
or the adapter
7
.
Use
Switching on and off
NOTE
► Always switch on the random orbital sander
before making contact with the material, then
apply it to the workpiece . During operation,
you can choose between instantaneous and
continuous operation
Switching on
♦ Press the ON/OFF switch
1
.
Switching off
♦ Release the ON/OFF switch
1
.
Speed preselection
♦ Select the required speed with the speed
control
5
.
Level 1: low speed
Level 6: high speed