![background image](http://html1.mh-extra.com/html/parkside/329707-2001/329707-2001_translation-of-the-original-instructions_758334025.webp)
PASSP 20-Li A1
GB
│
IE
│
21
■
WARNING!
■
To avoid potential risks, if the appliance
power cable is damaged, it must be replaced
by the manufacturer, its customer service or
by a qualified technician.
ATTENTION!
♦
This charger can only charge the following
batteries: PAP 20 A1/PAP 20 A2/PAP 20 A3.
♦
A current list of battery compatibility can be
found at www.Lidl.de/Akku.
Before use
Charging the battery pack (see fig. A)
CAUTION!
►
Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
NOTE
►
Never charge the battery pack at an ambient
temperature of below 10°C or above 40°C.
If a lithium-ion battery is going to be stored
for an extended period, the charge level
should be checked regularly. The optimum
charge level is between 50% and 80%. The
storage climate should be cool and dry and
the ambient temperature should be between
0°C and 50°C.
♦
Connect the battery pack to the high-speed
battery charger (see fig. A).
♦
Insert the mains plug into the mains power
socket. The control LED lights up red.
♦
The green control LED indicates that the
charging process is complete and the battery
pack is ready for use.
ATTENTION!
♦
If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged.
♦
If the red and green control LEDs both
flash, this means that the battery pack is
defective.
♦
Push the battery pack into the appliance.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions. Also
disconnect the power plug from the mains
power socket.
Inserting/removing the battery pack
Attaching the battery pack:
♦
Push the rotation direction switch into the
middle position (lock). Push the battery pack
into the handle until it clicks into place.
Removing the battery pack:
♦
Press the release button and remove the
battery pack .
Checking the battery charge level
♦
Press the battery charge level button to
check the status of the battery (see also main
diagram).
The status/remaining charge will be shown on
the battery display LED as follows:
♦
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Switching on/off
Turn on
♦
Press and hold the ON/OFF switch to start
up the tool.
The LED work light lights up when the ON/
OFF switch is pressed lightly or fully. This
provides illumination of the work area in poor
lighting conditions.
Switching off
♦
Release the ON/OFF switch to switch off the
appliance.
IB_329707_PASSP20-LiA1_LB8.indb 21
31.08.20 09:39
Summary of Contents for 329707 2001
