![background image](http://html1.mh-extra.com/html/parkside/322765-1904/322765-1904_translation-of-the-original-instructions_758005024.webp)
PAT 20-Li A1
GB
│
IE
│
19
■
ATTENTION!
♦
If the red control LED flashes, this means
that the battery pack has overheated and
cannot be charged.
♦
If the red and green control LEDs both
flash, this means that the battery pack is
defective.
♦
Push the battery pack into the appliance.
♦
Switch off the charger for at least 15 minutes
between successive charging sessions.
Also disconnect the power plug from the mains
power socket.
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦
Allow the battery pack to click into place in
the appliance.
Removing the battery pack:
♦
Press the release button and remove the
battery pack .
Checking the battery charge level
♦
Press the battery charge level button to
check the status of the battery (see also main
diagram).
The status will be shown on the battery display
LED as follows:
♦
RED/ORANGE/GREEN = maximum charge
RED/ORANGE = medium charge
RED = low charge – charge the battery
Filling the magazine shaft
Remove the battery before carrying out any
work on the power tool (e.g. maintenance,
changing tools, etc.) as well as during the trans-
port and storage of the power tool.
Unintentional activation of the trigger can result in
injury.
♦
Remove the battery pack from the appliance.
♦
Turn the appliance around.
♦
Press the release together (see fig. B).
♦
Pull the magazine slider backwards
(see fig. B).
♦
Fill the magazine shaft with staples or nails
(see fig. C).
NOTE
►
Ensure the correct position for the nails
(see main diagram, face plate on the
appliance).
♦
After filling, push the release into the maga-
zine shaft as far as the stop until it clicks into
place.
NOTE
►
The fill level indicator shows whether the
magazine contains staples.
Setting the impact force
NOTE
►
Select the lowest impact force sufficient for
stapling. Take into account the length of the
staples or nails you are using as well as hard-
ness of the material you are working with.
Increasing the impact force:
♦
Turn the impact force control clockwise.
Reducing the impact force:
♦
Turn the impact force control anticlockwise.
Operation
Switch on
♦
Press the tacker nose onto the location on
the material that you want to staple until it is
pushed in a few millimetres.
♦
Press the trigger .
Switching on the LED work light
♦
Press the button for the LED work light to illu-
minate your workspace in unfavourable lighting
conditions.
Summary of Contents for 322765 1904
Page 3: ...10 20 30 40 50 A B C...