Parkside 317249 1904, Translation Of The Original Instructions

Page: 23 / 87

PEH 30 C3 GB
│
IE
│
19 ■
♦ Push forward slowly and do not exert excessive
pressure on the plane sole . Excessive speed
reduces the surface finish and can lead to a jam
in the chip ejector.
Chamfering edges
The V grooves in the front plane sole allow
easy chamfering of workpiece edges.
♦ Use the V groove that corresponds to the chamfer
width required.
♦ Place the planer with the V groove onto the
workpiece edge and guide it forwards.
Using the rip fence
♦ To fit the rip fence, guide the connecting screw
8b
through the connecting piece
8a
and the rip
fence .
♦ Place the washer 8c
on the connecting screw
8b
.
♦ Screw the lock nut onto the connecting
screw
8b .
♦ Fit the rip fence onto the appliance using the
fastening screw .
♦ Undo the lock nut and set the desired width.
♦ Retighten the lock nut .
♦ Ensure that the plane is applied with lateral
pressure.
Using the fold depth stop
♦ Fit the fold depth stop onto the appliance
using the fastening screw .
♦ Set the desired fold depth using the fold depth
stop .
♦ Repeat the planing process several times until
the required fold depth is achieved.
Removing/replacing the planing
blade (see figs. C - E)
WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance.
CAUTION!
There is a risk of injury due to the cutting edges
of the planing blade !
Never touch the planing blade on its cutting
edges.
The planing blade has two cutting edges and
can be turned.
♦ Replace the planing blade when both cutting
edges are blunt.
♦ Do not try to sharpen the planing blade .
Turn the planing blade or replace it
WARNING! RISK OF INJURY
► Wear suitable protective gloves when changing
the planing blades.
NOTE
► Do not undo the two hex socket screws.
These are used for adjusting the height of the
cutter block. No adjustment is required if you
use the planing blades sold by the manufac-
turer. Use only the planing knives supplied by
the manufacturer.
► When changing the blade, always replace
both blades to prevent an imbalance.
► Unscrew only one blade to start with. This will
allow you to use the factory-mounted second
blade for reference when reassembling later.
♦ Use the supplied open-ended spanner to
undo the 3 fastening screws a little way so
that the planing blade can be moved
(see fig. C).
♦ Push the movable cutter block guard into the
slot in the housing.
♦ Push the planing blade sideways out of the
clamping element (see fig. D)