Parkside 306436, Translation Of The Original Instructions

Page: 36 / 55

PABS 20-LI D4 ■ 30 │
GB
│
MT
Before use
Charging the battery pack (see fig. A)
CAUTION!
► Always pull out the plug before you remove
the battery pack from or connect the
battery pack to the charger.
■ Never charge the battery pack when the
ambient temperature is below 10°C or above
40°C.
♦ Connect the battery pack to the rapid bat-
tery charger (see Fig. A).
♦ Insert the power plug into the socket. The con-
trol LED lights up red to indicate that the
appliance is charging.
♦ The green control LED indicates that the
charging process is complete and the battery
pack is ready.
♦ Insert the battery pack back into the appli-
ance (see Fig. B).
Attaching/disconnecting the battery
pack to/from the appliance
Inserting the battery pack:
♦ Push the rotation direction switch into the
middle position (lock) (see Fig. C). Allow the bat-
tery pack to click into the handle (see Fig. B).
Removing the battery pack:
♦ Press the release button and remove the bat-
tery pack (see Fig. D).
Checking the battery charge level
♦ Press the battery charge level button to check
the charge level of the battery (see Fig. E). The
status/remaining charge will be shown on the
battery display LED as follows:
♦ GREEN/RED/ORANGE = maximum charge/
performance
RED/ORANGE = medium charge/performance
RED = low charge – charge the battery
Changing tools
Your cordless drill has a fully automatic spindle
lock
.
When the motor is stopped, the power train locks
so that the chuck can be opened by turning
it
. After you have attached the desired tool
and tightened it by turning the chuck , you can
continue working (see Fig. F). The spindle lock is
automatically released when the motor starts (ON/
OFF switch pressed).
Torque selection ring/drill setting
You can set the torque using the torque selection
ring (see Fig. G).
♦ Select a low level for small screws or soft materials.
♦ Select a high level for large screws, hard materi-
als or removing screws.
♦ Select the drill setting for drilling work by adjust-
ing the torque selection ring to the position
(see Fig. H).
2 speed gearbox
CAUTION!
► Only operate the gear selection switch
when the appliance is at a standstill. Other-
wise the appliance can be damaged.
In first gear (gear selector switch in posi-
tion: 1)
(see Fig. I)
you can reach a speed of approx. 400 rpm and a
high torque. This setting is suitable for all screwing
jobs.
In second gear (gear selector switch in
position: 2)
(see Fig. J)
you can reach a speed of approx. 1400 rpm for
carrying out drilling work.