Parkside 298894, Translation Of The Original Instructions, Page: 13 / 47

PAMFW 20-Li A1
GB
│
IE
│
NI
│
CY
│ 9 ■
Fitting the sanding sheet onto the
sanding plate
♦ Place the sanding sheet centrally on the
sanding plate .
Changing tools
NOTE
► If you plan to use the dust extraction unit, it
must be connected before fitting or changing
the tool (see. section "Connecting a dust
extraction unit").
WARNING! RISK OF INJURY!
■ Always remove the battery before working on
the power tool.
♦ If necessary, remove an already fitted tool.
To do this, raise the tool release lever .
♦ Fit the tool (e.g. the plunge saw blade ) onto
the tool holder.
NOTE
► You can fit the tools in any snap position on
the tool holder.
♦ Lock the tool into place by pushing the tool
release lever back down again.
■ Check that the tool is fitted firmly. Incorrectly
or insecurely fitted tools can come loose during
use and cause you an injury.
Use
Switching on and off
Switching on:
♦ Push the ON/OFF switch forwards to switch
the appliance on.
The LED work light lights up when the appli-
ance is switched on to light up the working area
in low light conditions.
NOTE
► The LED work light can only be used when
the dust extraction unit is not fitted.
Switching off:
♦ Push the ON/OFF switch backwards to
switch the appliance off.
Selecting oscillation speed
♦ Use the speed adjustment wheel to set the
required oscillation speed.
Level 1: low speed
♦ Level 6: high speed
NOTE
► The required speed depends on the material
being worked and on the working conditions
and can be determined through practical
tests.