Parkside 298883, Original Instructions Manual

Page: 12 / 46

GB
│
IE
│
NI
│
CY
│
9 ■ PHKS 1350 C2
Connecting the sawdust extraction
appliance
♦ Attach the adapter for dust extraction to the
chip ejector .
♦ Connect an approved dust and chip extraction
device.
Operation
Switching on and off
Switching on:
♦ Push the safety lock-out to the left or right
and keep it pressed.
♦ Press the ON/OFF switch . Once the saw is
running you can release the safety lock-out .
Switching off:
♦ Release the ON/OFF switch .
Setting the cutting angle
You can select the cutting angle with the help of the
cutting angle scale .
■ Release the wing screw on the cutting angle
preselector , set the desired angle on the
cutting angle scale and then re-tighten the
wing screw.
Setting the cutting depth
NOTE
► We generally recommend setting the cutting
depth to approx. 3 mm more than the thickness
of the material. This ensures that you achieve
a clean cut.
♦ Release the locking screw , set the desired
cutting depth on the cutting depth scale and
then re-tighten the locking screw .
Working with the circular saw
1. Switch on the device – as described in "Switching
on and off" – and then place it with the front
edge of the base plate on the material.
2. Align the machine using the guide fence or
by using a marked line.
3. Hold the machine in both hands using the
handles and saw by exerting an even pressure.
Switching the laser on and off
Switching on:
♦ Press the ON/OFF switch laser .
Switching off:
♦ Press the ON/OFF switch laser .
NOTE
► If the batteries are spent, replace them with
two new 1.5 V alkaline button cells (type
AG 13/LR 44, e.g. GPA 76) .
Set rotational speed
■ Turn the adjusting wheel to the desired
rotational speed (arrow marking ▲)
(1 = lowest rotational speed/6 = highest rota-
tional speed):
Use the following suggested settings or set the rota-
tional speed on the adjusting wheel as required.