Parkside Performance PWSAP 40-Li A1, Translation Of The Original Instructions, Page: 80 / 107

PWSAP 40-Li A1 ■ 72 │
GB
│
MT
RISK OF INJURY!
► Note that when using the blade guard when
working with concrete or masonry, there may
be increased exposure to dust and a risk of
kickback.
► When using flange-mounted discs for a dual
purpose (combined grinding and cut-off
discs), use a blade guard suitable for abra-
sive cutting**.
** The blade guard for cutting must be ordered via the
service department.
♦ Open the clamping lever
a
.
♦ Place the blade guard u with the coding
lug s in the coding groove d .
♦ Turn the blade guard
u
to the required position
(working position). The closed side of the blade
guard
u must always be toward the operator.
♦ Close the clamping lever
a
to clamp the blade
guard
u
into position. If necessary, the clamping
force of the lock can be changed by loosening
or tightening the fine adjustment screw
p
.
Make sure that the blade guard
u
sits firmly
on the neck of the spindle.
Fitting the additional handle
CAUTION!
► For safety reasons, this appliance may only
be used with the additional handle
8 fitted.
Failure to do so can lead to serious injury.
The additional handle
8
can be screwed
onto the left, the right or the top, depending
on the job at hand.
Fitting/changing the roughing/
cutting disc**
Always wear protective gloves when changing
cutting/roughing discs.
Pay attention to the dimensions of the roughing/
cutting disc. The diameter of the hole must fit to the
mounting flange
i without any play. Do not use a
reducer or adapter.
NOTE
► Use only discs which are free of dirt.
■ Use only grinding discs whose permissible
speed rating is at least as high as that on the
type plate on the power tool.
■ RISK OF INJURY! Press the spindle locking
button
9
only when the mounting spindle
z
is
at a complete standstill.
♦ Press the spindle locking button 9 to lock the
gearbox.
♦ Undo the clamping nut
o
using the two-hole
assembly spanner 7 (see fig. B).
♦ Place the roughing or cutting disc with the label
side towards the appliance on the mounting
flange
i .
♦ Then replace the clamping nut
o
on the
mounting spindle
z
with the raised side facing
up.
With thin grinding discs (see fig. 1)
♦ The collar of the clamping nut o
faces upwards
so that a thin grinding disc can be fitted safely.
12
≤ 3,2 mm
Fig. 1
♦ Press the spindle locking button
9
to lock the
gearbox.
♦ Retighten the clamping nut o using the
two-hole assembly spanner
7
.
With thick grinding discs (see fig. 2)
> 3,2 mm
Fig. 2
The collar of the clamping nut
o
faces downwards
so that the grinding disk can be fitted securely onto
the mounting spindle
z .