Parkside Performance PAMFWP 20-Li B2, Translation Of The Original Instructions, Page: 56 / 79

54 GB/MT
¾
Inserting open end accessory tools: Place
the accessory tool into the accessory tool
holder 11 .
Inserting close end accessory tools:
Additionally, remove the clamping nut 10 .
Reattach the clamping nut after inserting the
accessory tool .
NOTE
u
You can attach the accessory tools into
the accessory tool holder 11 in any lock-in
position (Fig . H) .
Tightening the accessory tool
(Fig . G)
¾
Push the tool release lever 1 all the way
down .
Removing the accessory tool
(Fig . G)
¾
Fold the insert tool release lever 1 all the
way upwards (180°) .
¾
Removing open end accessory tools: Pull
the accessory tool out of the accessory tool
holder 11 .
Removing close end accessory tools:
Additionally, remove the clamping nut 10 to
remove such accessory tools . Reattach the
clamping nut after pulling out the accessory
tool .
¾
After removing the accessory tool: Push the
tool release lever 1 all the way down .
˜
Setting the oscillation speed
¾
Use the oscillation speed adjustment wheel
4 to set the oscillation speed (Fig . J) .
Setting 1:
Low oscillation speed
Setting 6: High oscillation speed
NOTE
u
The oscillation speed required varies by
material and working conditions and can
be determined with tests .
u
The oscillation speed can also be changed
during operation .
˜
Switching on and off
m
CAUTION! RISK OF INJURY!
Always wear protective gloves when
handling or working with the product .
m
CAUTION! RISK OF INJURY!
u
Always hold the product with both hands
while working (Fig . I) .
m
CAUTION! RISK OF INJURY!
u
Keep your hands away from the accessory
tool when the product is in operation .
m
CAUTION! HEALTH RISK!
u
Never work on materials containing
asbestos . Asbestos is considered
carcinogenic .
(Fig . K)
¾
Switching on: Slide the on/off switch 2
forward (
ON
) .
¾
Switching off: Slide the on/off switch 2
back (
OFF
) .