JINCHI05 RevD 21/05/14
11.
Remove the upper rear brick by lowering it
down into the firebox and out.
12.
The second upper side brick can now be
removed.
13.
Remove the lower side bricks by lifting the
brick until the bottom edge can clear the
support bracket. Then tilt slightly into the
firebox and lower out from behind the
tertiary air bar.
14.
Remove the lower rear brick by tilting the top
edge into the firebox and lifting out.
Installing the Stove
1.
Unpack the stove.
2.
Remove internal components.
3.
Move the stove into position inside the
fireplace opening being careful not to
damage the hearth or paintwork on the stove
and making sure that the rope seal is
compressed forming a tight seal between the
stove and fireplace.
4.
Drill into the existing fireback through the
fixing holes in the body, (see below) using a
6mm drill bit.
5.
Place the screws provided into the fixing
holes and gently tighten until the stove feels
secure.
6.
Fill the fixing holes with fire cement to form
an airtight seal.
7.
Seal the area where the throat meets the flue
outlet of the stove with fire cement.
8.
Refit the internal components.
FIXING HOLES
Rear View
