12
ASSEMBLY
3.
Attach the
engine stop cable
to the en-
gine. Models w ith Briggs & S tratton en-
gines are shown in Figure 6. Models with
Tecumseh engines are shown in Figure 5.
4.
Make sure the
engine stop cable
moves
freely. If the cable does not move freely, re-
peat the above steps.
CAUTION: A cable that is bent or damaged
will not work correctly. Before you use the
unit, replace a damaged cable.
5.
Attach t he
cable
t o the handle w ith the
cable fastener(s)
as shown in Figure 4.
CAUTION: If a cable fastener is missing, a
cable can be too near the muffler. Heat from
the m
er can damage the cable. Before
you use the unit, replace a missing cable
fastener.
WARNING: The blade will rotate
when the engine runs.
6.
Attach the
recoil start grip
and rope to
the right side of the handle with the
rope
guide
. Fasten with a
locknut
(Figure 7).
NOTE: If you cannot attach the recoil start
grip because the rope is too short, hold the
engine stop lever against the handle. Slow-
ly pull the recoil start grip.
Engine Stop
Cable
Engine
Stop Cable
Figure 5
Tecumseh
Engine
Figure 6
Engine Stop
Cable
Briggs
Engines
Engine Stop
Cable
Recoil Start
Grip
Figure 7
Locknut
15x116
Rope
Guide
uffl
