EN
| Operating manual
For your own safety
WVM 40 -1450
11
Safety notes on specifi c operating phases
Transportation and siting
◊
Only use suitable and technically perfect lifting gear with a suffi cient carrying capacity.
◊
Carefully secure the dryer during transportation.
Commissioning of the dryer
Risk of injury from suddenly escaping gas!
While the unit is under pressure, never remove any components or otherwise
interfere with the dryer! Suddenly escaping gases can lead to serious injury!
Prior to any work, release all pressure from the unit.
◊
Execute the stipulated tests and checks.
◊
On no account should the factory settings of the control programme be altered without
consulting the manufacturer.
◊
Prior to commissioning make sure there are no tools or foreign objects in, on or near the
dryer that could turn into a hazard for commissioning the dryer.
Emergency shutdow
◊
In any emergency, proceed as described in the section on page 36
Monitoring of the operation
Warning against sudden air ejection!
During expansion the pressure is released suddenly through the muffl er:
◊ A loud cracking noise occurs which can injure your hearing.
◊ Particles carried in the air can injure your eyes or skin.
Always wear eye and ear protection, therefore, when you are in the vicinity of
the dryer!
◊
Operate the dryer only within the permitted limits (see type plate). If the unit is operated
under conditions where the defi ned limit values are exceeded, it is exposed to stresses for
which it is not designed. This can result in malfunction or failure of the dryer.
◊
The higher the capacity of the dryer, the more noise it produces during operation. The oper-
ator must therefore provide suitable protective equipment (earmuffs).
◊
The dryer must be regularly inspected for visible damage. Any observed changes, includ-
ing changes in the operation behaviour, must be immediately reported to the responsible
person.
◊
In the event of an emergency and if safety-relevant malfunctions are observed (e.g. escap-
ing compressed air, higher noise level, defective components), the dryer must be immediate-
ly switched off (see page 36). The unit may only be restarted after all defects have been
eliminated.
Summary of Contents for Zander WVM 1080
Page 1: ...WVM 40 1450 Adsorption dryer Operating manual Revision 04 06_2018 EN Cod 398H271785 ...
Page 2: ......
Page 55: ......
