Service/Spare Parts Manual
Series V16
MSG30-5526-M1/UK
6
Parker Hannifin
Pump & Motor Division Europe
Trollhättan, Sweden
V16 Displacement limiter
Max and min displacement limiter consists of a hex
socket screw and stop washers or spacers, see fig. 1.
Suitable screw lengths for a particular max or min dis-
placement range are shown on page 7-10. What length
the max or min displacement spacer should have to ob-
tain a chosen displacement is shown on pages 7-10.
The displacement spacers are available in five different
lengths: 1; 1.5; 2; 5 and 10 mm. To obtain the right dis-
placement, the spacers can be combined with each
other’s. The thinnest spacer has to be mounted closest
to the setting piston, and the others in increasing length
order.
Displacement limiter
Displacement spacer changing
procedure:
1. Disassemble the max and/or min end cover/control
cover by loosening the screws for the chosen cover.
2. Loosen the socket head cap screw from setting pis-
ton.
Note:
This must be done when the end cap is as-
sembled on the motor, otherwise the feedback arm
could be damaged.
3. Choose spacer (s) to obtain right displacement, see
page 7 - 10, and place them on the socket head cap
screw.
4. Tighten the socket head cap screw in the setting pis-
ton. The tightening torque is 114 ± 10 Nm.
5. Assembly the end cover / control cover. The tighte-
ning torque is 114 ± 10 Nm for the screws.
Displacement screw
Displacement screw
Stop washer
Fig. 1 (M-version shown)
End cap
Note!