SD-476 / 92021
© 2021 Parker Hannifin Corporation
Parker Hannifin Corporation
Sporlan Division
206 Lange Drive • Washington, MO 63090 USA
phone 636 239 1111
fax
636 239 9130
www.sporlan.com
CAT5
CAT5
RS-485
RS-485
Alternate
Location #1
Alternate
Location #2
NOTE:
Each comm port
on BAS may need
a specific RS-485
address.
NETWORK DIAGRAM
(BAS & RS-485 cables are not required.)
representative and the iOS
mobile device of the technician
on site to connect with S3C Case
Control via Bluetooth.
ii. Allows the approval of certain
changes to S3C parameters but
will not override any existing
supervisory controller (BAS).
d. S3C Display Module
i. Instructions for the menu may
be found in Sporlan S3C I/O
Manual Bulletin 100-50-9.1
ii. Allows users with Technician
level or Administrative level
password to make changes on
their authority level.
iii. Find manual at http://solutions.
parker.com/literature-100.
iv. Other product literature found
at: solutions.parker.com/
sporlanliterature
5. RESOURCES
Sporlan Technical Support
a. E-mail: [email protected]
b. Phone:
888-920-6284
i. Extensive emergency support
for S3C Controls.
ii. Toll free in U.S.
iii. Dispatcher will send your
contact info to a Sporlan
representative that will call the
number you provide.
a. Please offer First
and Last name, Phone
number, Store Number,
City, and State along
with brief explanation
of the issue.
6. QUICK TIPS
-
For viewing settings, changing modes,
and other technician-level options, press
the service (wrench) button and enter the
Technician-level password. For setting
up the system or making configuration
changes, press the wrench button and
enter the administrative-level password.
-
Depending on the firmware revision of
the S3C Controller, the administrative
-level passwords may change daily.
Contact Sporlan for assistance.
-
To manually exit “Test” or “Charge
Pro” mode press the “ESC” button on
the S3C Display Module for 5 seconds.
-
To connect to S3C controller via
Bluetooth, hold down “ ” button for
5 seconds until signal indicator begins
flashing.
-
To initiate a manual defrost, press the
snowflake button and enter the
technician-level password. Then set DEF
to ON.
Figure above: Store network showing 4 comm loops into one BAS. A BAS is not required. Sporlan S3C controls can
operate cases and/or walk-ins as “stand-alone” controllers.
If multiple comm loops are attached to a single BAS, the RS-485 addresses will need to be determined from store
drawings or BAS provider. Default RS-485 address in S3C Controllers is “7”, but OEMs or technicians may need to
change to “8”, “9”, etc., as shown above.
