Parker Smog-Hog PCN, Owner'S Manual

Page: 8 / 22

4
SMOG-HOG Electrostatic Precipitator PCN Series
2. Installation
2.1 Packaging
The Smog-Hog PCN is shipped in three containers. One consists of the main cabinet and operating
components. The second is the factory-assembled extraction arm with duct in place. The third is the hood.
2.2 Inspection Note
Upon receipt of your unit, check for any shipping damage. A damaged carton indicates that the
equipment may have received rough handling during shipping that may have caused possible
internal damage. Notify your delivery carrier and enter a claim if any damage is found.
2.3 Installing the Extraction Arm Assembly
The top of the PCN cabinet has eight 3/8-16 threaded inserts in the cabinet, and equally spaced
around the air entry opening. The mating extraction arm mounting flange is ready for installation, and
the mounting hardware (bolts, flat washers, and split ring lock washers) is in a plastic bag inside the
main cabinet. The extraction arm assembly is approximately 50 lbs, but because of its size, may be
best positioned by two people. The extraction arm support spring is in place on the assembly, with a
protective shipping retainer box strapped in place (these must be removed before operating the unit).
All pivot points are tightened slightly to keep arms from moving during handling. This assembly is
shipped for installation so that the arm nearest the cabinet is in the vertical position when the bearing
flange is being bolted down. With this arm extending up from the top of the cabinet, a ceiling height
of about 10´ is required for adequate clearance. Refer to the SA Installation and Owner’s Manual for
instructions on assembling the extraction arm or making field adjustments.
!
C A U T I O N
Sharp pulls on the arm or hood should be avoided since damage to the arm components could result.