Parker SensoControl, Operating Instruction, Page: 7 / 21

page 5 of 21
3.1 Display Mode
The actual pressure (ACT) is indicated in the display mode. The ACT measured value is displayed in
the corresponding unit. The MIN, MAX or FS values is indicated in the lower part of the display.
Display Description
bar-graph
Graphic indication of the actual pressure.
A pressure peak is indicated by means of a pixel (graduation mark).
The indicated value is refreshed at intervals of
50 ms (20 measurements/s).
ACT
Indicates the actual pressure.
The indicated value is refreshed at intervals of 300 ms (3 times/s).
MIN/MAX
Indicates the MIN, MAX or FS value according to setting.
The indicated value is refreshed at intervals of 300 ms (3 times/s).
FS Full scale range (e.g. 400 bar)
Units
Indicates the chosen unit
Battery Indicates battery status (5 segments)
Send or Receive Mode
REC
REC flashes when recording measurement values
(optional data logging function)
x10 Indicated value (actual indication and MIN/MAX indication) x10
3.2 Menu Functions
Following set ups can be done within the MENU Function:

Automatic switch off enable/disabled

Selection of engineering units (bar/mbar/PSI/kPa/Mpa.)

Filter settings

REC time or REC auto function

Delete data memory
By pressing the MENU key (2 s) the desired function appears.
Skip to next function by pressing MENU again.
Confirmation by pressing the „OK“ key.
The
ServiceJunior wireless returns into the display mode.