Parker PSD1, Installation Instructions Manual

Page: 60 / 109

Installation of the multi-axis system PSD1-M
60 (109)
192-011006N8 2019-07 09.10.19 09:27
*Display of error numbers by flash sequence
Green LED: Decimal
1 flash = 10; 2 flashes = 20; 3 flashes = 30; ...
Red LED: Single figure
1 flash = 1; 2 flahes = 2; 3 flashes = 3; ...
Adding both values results in the error number.
Display sequence:
•
Green LED = OFF, red LED on for 5 s
• Green LED 1 … 9 flashes, depending on the error number.
• Red LED 1 … 9 flashes, depending on the error number.
•
Green LED off and red LED off for 1 s).
This sequence repeats until the error is reset.
Meaning of the error numbers
11 Phase error
12 Voltage DC bus too low
13 Voltage DC bus too high
21 Temperature in the rectifier too high
22 Braking circuit overloaded
23 Temperature in the braking resistor too high
24 Short-circuit in the braking circuit
25 Rectifier overloaded
31 Voltage DC bus too high
32 Voltage offset DC bus too high
41 Overcurrent at digital output
51 None or wrong EEPROM - Data
Caution - Risk of electric shock!
High voltage supply may be present even with missing voltage supply (both
LEDs off)!
5.12.3. S2: Modes switch (Power module)
Switch
position Operating mode
0 standard
1 Increased performance by line choke mode
Warning! Operating without line choke can destroy the device.
2 ... F Not defined
Acceptance of the switch position when switching on 24 VDC Control
voltage.
5.12.4. S3: Voltage switch (Power Module)
Switch
position
Supply-
voltage
Load Circuit Umax
Turn-on
threshold [VDC]
Turn-off
threshold [VDC]
[VDC]
0 3AC400V 780 770 810
1 3AC110V 780 770 810
2 3AC230V 780 770 810
3 3AC380V 780 770 810
4 3AC480V 780 770 810
5 3AC230V 390 380 410
6 3AC110V 390 380 410
7 1AC230V* 390 380 410
8 1AC110V* 390 380 410
9 ..F factory use