Parker Pro Display 10 Instruction Book
23/53
according to OEM’s required IP rating, outside of the Pro Display shall be taken into
account in the end application environment.
4.6.3. RS232
One RS232 port is provided and available on main connector C2. The port consists of
TX, RX and GND signals. There is no handshaking. Baud rate is configurable up to
115200 bps.
4.6.4. Ethernet
Pro Display has one IEEE 802.3 compliant 10/100 Ethernet interface. Possible baud
rates are 10 or 100Mbps. Ethernet port can be designated for computer communication
as well as uploading or downloading applications and diagnostics, or it can be used for
an in-vehicle network over Ethernet in cases of devices with Ethernet connections.
Static IP address setting and DHCP client are supported.
4.7. HMI (Human-Machine Interface)
Human–Machine Interface consists of projective Capacitive Touchscreen (PCAP) and
high resolution TFT LCD display.
4.7.1. Touchscreen
Projective Capacitive Touchscreen (PCAP) supports multipoint finger and stylus-touch.
Pro Display is intended for in-cabin use. Unit will not be damaged by water as it has IP65
rated ingress protection.
Touchscreen may have limited functionality if excessive amount of water gets onto the
touchscreen. Therefore, it’s always best practice to ensure that water droplets are able
to roll off of the screen by placing the display in a vertical or at least a slightly angled
position in the end application environment. Touch sensor is tuned to reduce the risk of
unintentional activation by, for example, water droplets.
Display glass can be cleaned with an LCD cleaning solution and cloth. Use a non-
abrasive cloth for cleaning the display.
NOTICE: To avoid scratches, do not wipe or clean a dry display.
NOTICE: Reasonable care should be taken to maintain the glass.