Parker PowerStation XP Series, User Manual, Page: 30 / 65

Chapter 3: Starting Your PowerStation PowerStation Connectors
XP Series PowerStation User Guide 3-3
Settings and Pinouts for COM1
If you need to make a cable for communicating with COM1, Table 3-1
shows the pinouts and signal information for this port.
Table 3-1: COM1 Pinouts
Settings and Pinouts for COM2 on the XPR00 & XPx06
If you are using the XPx06 and need to make a cable for communicating
with COM2, Table 3-2, shows the pinouts and signal information for this
port.
Table 3-2: COM2 Pinouts for the XPR00 & XPx06
If you need to make a cable for communicating with COM2, you may need
to set the DIP switch settings.
Pin# Signal
1 DCD, data carrier detect
2 RXD, received data
3 TXD, transmitted data
4 DTR, data terminal ready
5 Signal ground
6 DSR
7 RTS, request to send
8 CTS, clear to send
9 RI
Pin# RS-232 Signal
RS-422
Signal
RS-485
Signal
1 N/C TXD-, transmitted
data -
TXD-, transmitted
data -
2 RXD, received data TXD+, transmitted
data +
TXD+, transmitted
data +
3 TXD, transmitted
data
RXD+, received data
+
RXD+, received data
+
4 N/C RXD-, received data
-
RXD-, received data
-
5 Signal ground Signal ground Signal ground
6 N/C N/C N/C
7 RTS, request to send RTS, request to send RTS, request to send
8 CTS, clear to send CTS, clear to send CTS, clear to send
9 N/C N/C N/C