Chapter 2: Installing the PowerStation
Installing the XP PowerStation
XP Series PowerStation User Guide
2-9
Mounting a PowerStation With an 8” Display
If you are mounting a PowerStation with a 8” display, complete the
instructions below:
1
Slide the PowerStation into the cutout from the front.
2
Attach the 4 mounting clamps, with their screws to the back of the
unit in the spaces provided. You will place 2 clamps on the top and
bottom of the unit.
The clamps secure to the unit using the sliding mechanism shown in
Figure 2-3: Sliding Mechanism for the 8” PowerStations
3
Slide the feet of the mounting clip into the slot, then slide the clip
over to properly mount the unit.
4
Tighten each of the mounting screws against the front of the
enclosure.
5
Torque them down to
7 in/lbs
.
6
Tighten the screws in a crosswise sequence to ensure a good seal
and prevent damage. Tightening the bracket assembly may not
ensure that the gasket seal is totally depressed by the bezel. You
may see a small gap between the bezel and the enclosure.
Figure 2-4: Clamp Shape for an 8” PowerStation Display