EN
| User Manual
Technical product description
14
KA-MT 10-95/D3
Technical product description
Summary Drawing Standard Dryer*
Function description
The dryer dries the compressed air supplied by the compressor and makes it available for
industrial use.
Upstream fi lters clean the compressed air and remove dust, dirt, oil, and water droplets, be-
fore the compressed air reaches the dryer. Thus, an upstream fi lter is also used for extending
the service life of the drying agent.
Downstream fi lters clean the compressed air from drying agent abrasions, before it is fed into
the compressed air system.
The two chambers of the hollow section vessel contain an extremely porous drying agent by
means of which humidity is removed from the compressed air and stored just as in a sponge.
The stored humidity is then removed again from the drying agent and re-introduced into the
ambient environment.
To this end, the two chambers alternate between different operating modes. Whilst in one
vessel, compressed air is de-humidifi ed (adsorption), in the other vessel the humid drying
agent is prepared for another charge (regeneration). These two states, which run in parallel
during compressed air preparation, are described below.
Check valve block
Compressed air outlet
On/Off-Switch
Compressed air inlet
Upstream fi lter
Power supply connector
Downstream fi lter
Control cabinet
Muffl er
Discharge point
Vessel
Vessel pressure gauge
Oil indicator OP01
Solenoid valve block
Summary of Contents for KA-MT 10-95/D3
Page 2: ......
