PowerTilt Tilting Coupler
PowerTilt Series Service & Repair Manual
HY34-1410
48
Parker Hannifin Corporation
Helac/Cylinder Division
Enumclaw, Washington USA
www.parker.com/helac
3.
Using a pry bar, continue to rotate clockwise
and tighten until the thrust washer (344)
makes contact with the housing (01) collar.
5.
Then install the lock ring (05), trying different
splines to find the best alignment between
the lock ring splines and the end cap (04)
holes. If the holes do not align, thread the
end cap by no more than one spline tooth to
align the holes.
4.
Remove the two screws and tighten the
end cap (04) using a torque wrench and
customized end cap tool to the torque
specifications shown on the End Cap Torque
Chart on Page 41.
1.
Before installing the end cap (04), coat the end
cap and shaft threads with anti-seize grease.
2.
Install two screws into the end cap. Thread
the end cap (04) onto the shaft (02) until the
seal contacts the housing.
Assembly
End Cap and Lock Ring Installation
