Page
2
of 7
ECO-0438955
REV:A
Installation and Operation Manual
Needle Valves & Ball Valves
NPT:
Use standard practice for NPT taper threads. Use an appropriate thread tape or sealant to
prevent galling.
A-lok/CPI
: See separate instruction sheet supplied with A-lok products. For full instruction and best
practice on fabrication and installation of tube and A-lok/CPI tube fittings, scan the QR code below. *
When fitting A-lok/CPI, care should be taken to ensure that the end connector (1)
(fig1)
is firmly held
by an appropriate spanner / wrench (the size varies depending on the size of valve) to prevent any
movement when assembling or disassembling pipe or tube connections.
O-Lok
: Take care to not damage the captive O-ring. For full instructions on O-lok assembly and
installation, please refer the O-lok section on page 55 of our Tube Assembly Guide which can be
found by scanning the QR link below. *
*For text versions of these QR codes, please See ‘Further Information’ at the end of this guide.
HANDLING AND STORAGE
Handling
Parker Products that utilise Needle and Ball Valves may be heavy. Ensure that local manual handling
requirements are followed.
Do not lift or carry by the operating handles, as this may cause damage.
Storage
There is no specified shelf-life.
Boxed products should be stored in a covered area, preferably indoors, and away from excessive
moisture, heat, or airborne contaminants.
The use of desiccant or corrosion inhibitors is not required during normal storage periods.