Parker EME
Belt / belt tensions
192-550003N10 ETH ATEX December 2019
51
A
Accessory mounting - bearing block • 27
Applications in accordance with the Regulations
• 12
Applications not in accordance with the intended
use • 13
ATEX and machinery directive • 10
ATEX declaration of conformity • 7
ATEX specific safety instructions • 16
B
Belt / belt tensions • 50
C
Checking the toothed belt • 47
Commissioning • 24
Conditions of utilization • 22
Cylinder mounting with mounting plates or foot
mounting brackets • 25
D
Device assignment • 5
Direction of the motor during extension of the
cylinder • 30
E
Electrical installation • 30
ETH ATEX marking • 11
Exchanging the toothed belt (ETH032 ... 080 • 48
Exchanging the toothed belt (ETH100&125) • 49
Explosion subgroup • 10
Explosive atmospheres • 8
F
For Safety Use • 14
G
General hazards • 14
General safety instructions - ATEX • 16
H
Harmonized European ATEX Standard • 8
I
Identifying Residual Dangers and Hazardous
Areas • 14
Introduction • 5
Introduction to ATEX • 8
IP65 motor mount • 42
IP65 motor mount parallel • 43
L
Lubricating intervals and amount of lubricant for
ATEX ETH- Electro Cylinder • 45
M
Maintenance and service • 44
Maintenance schedule • 44
Motor / gear assembly with inline motor
configuration • 33
Motor / gearbox mounting with parallel motor
configuration • 35
Motor mounting for IP65 inline • 42
Motor/ gear assembly • 32
Mounting • 24
Mounting explanation • 6
Mounting of force sensors • 29
Mounting of proximity switches • 30
Mounting of the payload • 28
Mounting the rod guide (option R) • 27
Mounting with mounting accessories • 25
Mounting with mounting threads on the cylinder •
25
O
Operator’s obligations • 13
P
Packaging, storage, transport • 17
Parallel mount ETH100
Parallel mounting ETH032 ... ETH080 standard •
35
Parallel mounting ETH032 ... ETH080 with Ex -
Motor • 37
Planning of the ETH Electro Cylinder for
EX-Environment • 23
Product specific safety instructions • 16
R
Re-apply toothed belt pre-tension • 41
Relubrication via central lubrication port (option)
• 46
Relubrication via central lubrication port
(standard) • 45
Resetting the toothed belt pre-tension • 41
S
Safety Instructions for Operating Personnel • 15
Safety Instructions for the Company Using the
System • 15
Screw tightening torques for the mounting of the
customer’s ETH cylinder • 25
Sensors • 30
Setting the end limits • 31
Side Load • 28
Special notes on transport • 18
Supply repair • 50
T
Temperature classes • 10
Terms of guarantee / warranty • 21
Toothed belt • 47
Toothed belt exchange • 47
Type identification plate • 5
Type of explosion protection • 9
W
Working safely • 14
Z
Zone classification / device categories • 9
5. Index
