Parker EME
Setting up Compax3
192-120101 N11 C3I11T11 November 2007
211
4.4.9.7
Overview of the user interface
In this chapter you can read about:
Selection of the signal or system to be measured. ..........................................................................211
Frequency settings ..........................................................................................................................215
velocity control .................................................................................................................................215
Other settings ..................................................................................................................................217
Operating and status field................................................................................................................219
Display of the measurement result ..................................................................................................221
Dispaly of the measurement point at the cursor position.................................................................222
5
2
6
3
1
4
(1)
Selection of the signal or system to be measured
(see page 211)
(2)
Frequency settings
(see page 215)
(3)
Other settings
(see page 217)
(4)
Operating and status field
(see page 219)
(5)
Display of the measurement result
(see page 221)
(6)
Dispaly of the measurement point at the cursor position
(see page 222)
Selection of the signal or system to be measured.
In this chapter you can read about:
Position control ................................................................................................................................212
Current control .................................................................................................................................213
Mechanical system ..........................................................................................................................214
With the aid of the tree structure, you may select what you want to measure. Here,
the selection is made, if a frequency spectrum or a frequency response is to be
measured.
The shown structures are simplified in such as all feedbacks are displayed without
special transmission behavior. This is surely not the case in reality, serves however
a better overview.
