Setting
up Compax3
Positioning via digital I/Os
112
192-120101 N11 C3I11T11 November 2007
In the ROLL operating mode, marker functions and set trigger level positions are
not available.
4.4.2.2
User interface
In this chapter you can read about:
Oscilloscope operating mode switch: ..............................................................................................113
Setting the time basis XDIV .............................................................................................................114
Settings for channels 1..4 ................................................................................................................114
Trigger settings ................................................................................................................................115
Special functions..............................................................................................................................116
1:
Operating mode switch
(see page 113) (Single / Normal / Auto / Roll)
2:
Setting the time basis
(see page 114)
3: Starting / Stopping the measurement (prerequisites are valid channel sources
and if necessary valid trigger settings.)
4:
Setting channel
(see page 114) (Channels 1 ...4)
5:
Special functions
(see page 116) (Color settings; memorizing settings and
measurement values)
6: Loading a measurement from Compax3: in the single mode you can close the
ServoManager after the activation of the measurement and disconnect the PC from
Compax3 and upload the measurement later.
7:
Setting triggering
(see page 115)
8: Copy osci display to clipboard
9: Zoom of the osci display (1, 2, 3, 8, 16 fold) with the possibility to move the zoom
window (<,>)
