Compax3 device description
High power devices
24
192-120149 N08 June 2014
3.4.3.
Compax3H connections front plate
Communication and signal interfaces
X20
X21
X22
X23
S24
X12
X13
X11
X3
LED3
LED2
LED1
X4
X10
Showcase front plate of the control (number of connectors depends on the
extension level of the Compax3)
X3
Motor brake
X20
HEDA in (Option)
X4
24VDC
X21
HEDA out (Option)
X10
RS232/RS485 with jumper to the
programming interface
X22
Inputs Outputs (Option M10/12)
X11
Analog/Encoder
X23
Bus (Option)
Connector type
depends on the bus
system!
X12
Inputs/Outputs
S24
Bus settings
X13
Motor position feedback
LED1
Device status LEDs
LED2
HEDA LEDs
LED3
Bus LEDs
The
internal
device status LEDs are only connected to the
external
housing LEDs,
if the RS232 jumper at X10 is fitted to the control and the upper dummy cover is
fitted.
The RS232 programming interface under the upper dummy cover is only available if
the X10 jumper at the controller is fitted.
3.4.4.
Plug and pin assignment C3H
AC - Versorgung
AC - Supply
DC - Versorgung
DC - Supply
X4 (24VDC)
RS232
SSK1
PC
Compax3
Further information on the assignment of the plug mounted at the particular
device can be found below!
Note on Compax3H:
Overview
This manual was downloaded on www.sdsdrives.com
+44 (0)117 938 1800 - [email protected]
