|
w w w . p A r k e r g u i t A r S . c O M
|
|
w w w . p A r k e r g u i t A r S . c O M
|
13
Quick StArt checkliSt
here is a checklist of things you need to do before playing the Adrian
Belew Signature guitar
install a fresh 9 Volt Alkaline battery in the compartment on rear
1.
cover of instrument.
Start with the volume & tone controls on the guitar pushed
2.
in and turned counterclockwise and the Variax knob in the
up position. Be sure gain is down on all other controls in your
system.
connect the Adrian Belew Signature Fly guitar to the supplied
3.
power regulator with a 13-pin Midi instrument cable. (13-pin
cable not included).
connect the included power regulator to your guitar
4.
synthesizer using the attached 13-pin cable. nOte cAreFully:
the power regulator input and power regulator output use the
same style connector, and could be interchanged if you don’t
pay attention. getting these backwards could damage the
instrument, the power regulator, your synthesizer, or all three.
please be careful!
plug the line 6 power transformer into the power regulator Ac
5.
input jack.
plug the line 6 power transformer line cord into a 110 VAc wall
6.
outlet.
check that the synthesizer output and the guitar through
7.
output are both connected. If using guitar amplifiers, you’ll
need two 1/4” cables. if using a mixing or recording console,
you’ll need two direct interface (di) boxes and xlr cables.
we recommend you use a volume pedal connected inline with
8.
the synthesizer output.
Switch the Sustainiac Standby switch on rear cover of
9.
instrument to the On position. Be sure the green led in the
switch slider lights up.
turn on power to synthesizer and any other outboard
10.
equipment, working your way towards the amplifiers or mixing
console.
Bring gain up slowly while strumming the guitar.
11.
