Chapter
➂
I
nstallation
7
RP240 Dimensions
The following figure shows the dimensional drawing for the RP240.
Mounting holes and their dimensions are given.
Compumotor
RP240
1.50
8.70
8.10
6.90
0.90
6.90
0.60
1.95
0.83
0.76
0.60
Interface Connector
Location
Mounting holes
8-32 UNC (4 Plcs)
GND
Rx
Tx
+5V
RP240-NEMA4 Door Mount
To mount the RP240-NEMA4 operator panel through the door of an
enclosure, or in a panel, follow the steps below.
➀
Cut an 8.3 inch vertical by 8.9 inch horizontal hole in the door of the enclosure
or panel as shown on the following page.
➁
Drill eight holes in the locations shown.
➂
Place the gasket (provided) on the RP240-NEMA4.
➃
Put the operator panel through the door and tighten the eight nuts provided.
➄
Connect the 4 wires between the operator panel and the Extended X (SX, ZX, or
Model 500) or the 6000 Series (6200 or 6250) product.
The following figure shows the dimensional drawing for the RP240-NEMA4.
Mounting studs and the required diameter clearance holes are given.
9.95
9.35
1.55
0.25
9.40
7.45
1.95
0.28
8.80
7.15
1.65
0.28 0.53
0.187 Diameter Clearence Holes
For #8-32 UNC-2B Studs (8x)
8.90 (Recommended Panel Cutout)
0.53
8.30 (Recommended Panel Cutout)
GND
Rx
Tx
+5V
RP240
Compumotor
