when left alone)
Place straight edge between rails and set so that they are 90
degrees vertical to knife and flat to one another.
TABLE ASSEMBLY
Assemble table on tracks ensuring that LHS (with side guide
rollers) is place to engage carefully with LH guide rail.
Bolt table sides together
Fasten rails to floor with 3/8” “Loxins” or similar
FENCE ASSEMBLY
The fence has an adjustable handle at the operators end and
moves on geared racks attached at both ends of table.
Fit slotted rack to front(operator end) of RH table and other rack to
rear of RH table
Remove “L” shaped casting from rear of fence taking care not to
dislodge brass rubbing strips.
Place fence on table with “L” shaped casting (operator end) clear
of rack then carefully push/slide/giggle assembly and gear pinion into
egagement with racks at operator and rear end checking fence face is
parrell to knife slot in table.
Refit “L” shaped casting at rear
Use the front(slotted) rack to adjust fence parrell to knife slot
Use nut locked grub screws to adjust fence face square to table
top at both ends
INSTALLATION FINISHED
