Park DT-814175, Owner'S Manual

Page: 58 / 64

12
SHARPENING WEDGE SHARPENING WEDGE SHARPENING WEDGE SHARPENING WEDGE
After using the log splitters for some
time, sharpen the wedge of the log splitter using a fine-toothed file and
smooth any burrs or crushed area along
the cutting edge.
TROUBLE SHOOTING TROUBLE SHOOTING TROUBLE SHOOTING TROUBLE SHOOTING
PROBLEM PROBLEM PROBLEM PROBLEM PROBABLE CAUSE PROBABLE CAUSE PROBABLE CAUSE PROBABLE CAUSE REMEDY SUGGESTED REMEDY SUGGESTED REMEDY SUGGESTED REMEDY SUGGESTED
Fails to split
logs
Log is improperly positioned
Refer to “ Log Splitter Operation”
section for perfect log loading.
The sizes or hardness of the
log exceeds the capacity of
the machine Reduce the log sizes before
splitting it on the log splitter
Wedge cutting edge is blunt
Refer to “ Sharpening Wedge
“ section to sharpen the cutting
edge.
Oil leaks Locate leak(s) and contact the
dealer
Unauthorized adjustment
was made on Max.
Pressure Limiting Screw.
Lower max pressure rating
was set.
Contact the dealer.
The log pusher
moves jerkily,
taking
unfamiliar
noise
or
vibrating a lot
Lack of hydraulic oil and
excessive air in the hydraulic
system.
Check oil level for possible oil
refilling.
Contact the dealer.
Oil leaks
around
cylinder ram or
from
other
points.
Air sealed in hydraulic
system while operating.
Loosen Bleed Screw by 3 ~ 4
rotations before operating the log
splitter
Bleed Screw is not tightened
before moving the log
splitter.
Tighten the Bleed Screw up before
moving the log splitter.
Oil Drain Bolt with Dipstick
is not tight. Tighten the Oil Drain Bolt with
Dipstick.
Hydraulic Control Valve
Assembly and / or seal(s)
worn Contact the dealer