—8—
Instructions
1.Turn On/Off
:
2.Sleep Mode
:
3 The Eyepiece Dioptre Adjustment
.
a long press of Power button. Power indicator will keep light when the device is
turned on.
Enter sleep mode with a short press of Power/Sleep button when the device is
on. Power indicator will keep light when the device enters sleep mode.
The purpose of dioptre adjustment is to get a clear image for users with different
vision. Rotate and adjust the dioptre adjustment ring until you get a clear view of
the four-character icon on the screen. One adjustment only for each eye.
(Please note that the image is not clear normally without the adjustment of objective
lens.)
—9—
5.IR Fill Light Control
Turn on the device, enter black and white mode with a long press of IR button.
Switch to IR level 1-3 or off with a short press of IR button. The part of fill light is
stretchable which can be twisted out or back to make an quick adjustment.
4.The Objective Lens Adjustment
rotate and adjust the objective lens ring until you get a clear and well-focused
image.
—10—
6.Red Dot Adjustment
7.Menu operation
Turn on the device, then turn the laser on/off with a long press of Laser/Menu
button. The position of laser can be adjusted on the laser adjustment holes by a
hex-nut wrench.
Enter the menu with a short press of Menu button. Press +/- button to select
options. Enter a submenu with a short press of OK button. Exit the menu with a
short press of Menu button.
—11—
3. Mount Installation
2.Adjustments
Rotate and adjust the eyepiece dioptre adjustment ring until you can see the
four-character icon on the screen ( there's no need to see a clear image ), then
rotate the Objective lens adjustment ring until you can see the target clearly. Next,
switch to different modes, test IR, Red dot and Rangefinder to check the function of
the device.
There are five mounting holes in the base of the device. Attach the mount to
the base of the device by using a hex-nut wrench and screws. The mount can be
installed in multiple rails.
Range Unit Selection
Reticle Adjustment
Default Color
Brightness Of IR
PIP
Default Magnification
Gyroscope
Ballistic Calculation
Enter the
by
a
press
of
OK
button,
then
press "+" or "-" button
to
switch among ballistic calculation Parameters/ON/Off options.
.
BC Setting
Confirm your
selection with a short press of OK button
After entering the ballistic calculation parameter setting, press the menu/ok
button to move up and down to select sub-options and +/- button to adjust the
Turn on the device with a short press of Power button.Turn off the device with
Make sure the eyepiece dioptre adjustment is finished. Aiming at your target,
1>BC Setting (Ballistic Calculation)