REMOTE CONTROL HANDSET
The remote control has a range of approximately 20 - 25 feet (6 - 7.5 meters). Use only AAA
alkaline batteries in the handset and insert them according to the + and - polarity markings in
the battery compartment.
Zone Code
You can select different remote command codes to control up to four Ztuners independently
with the same wireless remote control system. Program the remote handset to the number
1-4 that corresponds to the Zone switch number on the Ztuner.
Notes
:
- The remote handset will not operate the Ztuner unless its zone code number matches the
Ztuner Zone selector switch setting. The purpose of separate zone codes is to enable as many
as four Ztuners to operate independently in the same installation.
- The factory settings for the remote handset and the unit’s Zone switch are 1.
Setting the Zone Code
To set the remote zone code, press both the Zone key and the key 1-4 which corresponds to
the setting of the Ztuner Zone switch. These keys must be pressed simultaneously for about
1.5 seconds.
When the same zone code is programmed in the Ztuner and the remote handset the display
will look like this example for a few seconds.
ZONE 1 refers to the Ztuner zone setting and R Zone 1 refers to the remote handset program-
ming. In this example, both are set to Zone 1 and the remote will control the unit.
However, if the Ztuner and the remote handset are set up with different zone codes the display
will display the mis-match for a few seconds.
In this example the Ztuner Zone switch is set to Zone 3 and the remote handset is programmed
for Zone 1. The remote is unable to control the unit.
On and Off Keys
These have the same function as the Power button on the front panel.
Press On to turn the Ztuner on. The display will illuminate.
Press Off to turn the Ztuner off. The display will flash OFF as the unit turns off.
These separate keys enable programming unambiguous “hard” on and off commands into a
system controller or to create a macro sequence for a learning type remote control.
Note
: These keys will not function when the rear panel Auto On switch is set to Auto.
ZONE 3 R ZONE 1
FM 103.7 MHz P23
ZONE 1 R ZONE 1
FM 103.7 MHz P23
11
