Parasound HALO JC, Owner'S Manual

Page: 6 / 22

CONNECTING A PREAMPLIFIER OR A SURROUND
CONTROLLER TO THE UNBALANCED INPUT ON YOUR JC 1
3
1
2
RCA Plugs
Right
Left
3
&
4
Right
Left
COMPONENTS
SURROUND
SOUND
CONTROLLER
PREAMP
OUTPUTS
or
None 4
8 12
20 50
100 200
Auto Turn On
Delay
Seconds
Sensitivity
Input mV
Select
< <
Select < <
Audio
Signal
<
Manual
12V Input
12 Volt
Trigger
Trigger
Output
JC1 Amplifier
Parasound Products. Inc.
San Franscisco, CA USA
Ground
Normal Lift
Fuse
T15A/250V-115V Area
T8A/250V-230V Area
Power Consumption: 1200W
AC 115V 60Hz
AC 230V 50Hz
CAUTION
To Prevent Electric Shock, Do Not
Remove Cover. No User-Serviceable
Parts Inside, Refer Servicing To
Qualified Service Personnel.
Bias Level
Reduced Normal Unbalanced Input Balanced Input
Speaker
1 2
WARNING
To Prevent Fire Or Shock Hazard,
Do Not Expose This Unit To Rain
Or Moisture.
Manufactured under
license from Lucasfilm
Ltd. Lucasfilm and THX
are registered Trademarks
of Lucasfilm Ltd.
1
2 4
3
Unbalanced Input
Use this input if your preamplifier or surround controller doesn’t have balanced output
connectors or if you simply prefer to use unbalanced connections.
What You’ll Need:
• One shielded interconnect cable with RCA plugs
• A source component with RCA output jacks
Before Connecting
Leave the AC cord on the JC 1 disconnected until you have made all other
connections to prevent any surprise burst of sound.
Make sure that all your cables are long enough so they are not strained or
stretched once they are connected.
Make sure the Select switch on the JC 1 is in its Unbalanced Input (left) position.
To Connect
Plug one end of the cable into the Unbalanced Input jack on the JC 1.
Plug the female end of this cable into the desired channel output jack on your
preamplifier or surround controller.
Repeat steps 1 and 2 above to connect additional amplifiers.