XLR Connectors
Male
Female
YOU SHOULD KNOW
Balanced XLR Jacks and Their Pin Configuration
The balanced inputs of the A 21 use XLR jacks that conform to the industry standard of:
Pin 1: Ground, Pin 2: Positive (+), Pin 3: Negative (--). The balanced outputs on some
components use terminals with 3 screws instead of XLR jacks. These are compatible with
the A 21 as long as you match the bare wires to the corresponding pins on the XLR plug: +
to pin 2, - to pin 3, and Ground to pin 1.
CONNECTING A STEREO PREAMPLIFIER OR A SURROUND
CONTROLLER TO THE BALANCED INPUTS ON YOUR A 21
1
2
3
&
4
2
3
Left
Right
COMPONENTS
SURROUND
SOUND
CONTROLLER
PREAMP
OUTPUTS
or
1
2
3
1
2
3
4
2
1
Left and Right Balanced Input Jacks
Balanced connections will give you the best sound. If your preamplifier or surround controller
has balanced XLR output jacks, we recommend that you connect them to these inputs. Refer
to the
Balanced and Unbalanced Lines
in the
Technically Speaking
section for additional
information about why we recommend using balanced lines.
What You’ll Need:
• One pair of balanced interconnect cables with XLR connectors
• A preamplifier or surround controller with balanced outputs
Before Connecting
Leave the A 21’s AC cord disconnected until you have made all other connections to
prevent any surprise burst of sound.
Make sure that all your cables are long enough so they are not strained or stretched
once they are connected.
Make sure the
Inputs
switch on the rear of the A 21 is in its
Balanced
(up) position and
the
Ground
switch is in its
Normal
(down) position.
To Connect
Plug the male end of the balanced interconnect cable into the
Balanced Right Channel
input jack on the A 21.
Plug the female end of this cable into the balanced
right channel output jack on
your preamplifier (or a channel on your surround controller).
Repeat steps 1 and 2 above to connect the left channel.
