-3-
Flatten Here
Flatten Here
Installation Instructions for NC/K-M Rough-In Kits
Follow these instructions if you will cut the final hole for the speaker with a pin router.
1. Determine the final cut-out location of the Custom Series loudspeaker.
2. Install one of the 25” mounting bars horizontally between
two studs with the slot facing up and toward you.
3. Use a level or carpenter’s square before nailing or screwing
the bar into the studs.
4. Slide the cut-out frame into the desired location with the
3/8” tabs facing toward you.
5. Place the other 25” horizontal bar onto the top of the cut-out
frame and nail or screw it into the studs.
6. Flatten the outer edge of the slot of the mounting bars
against the studs with a hammer to keep the frame from
sliding.
7. Once the drywall has been hung, use a pin router to cut out
the hole against the outer edge of the cut-out frame.
8. Install the Custom Series loudspeaker as shown above in
Installing in Existing Walls and Ceilings.
Note: Follow these instructions if you will cut the final hole for the speaker with keyhole saw.
1. Determine the final cut-out location of the Custom Series loudspeaker.
2. Install one of the 25” mounting bar horizontally between two studs
with the groove facing up and toward you.
3. Use a level or carpenter’s square before nailing or screwing
the bar into the studs.
4. Slide the cut-out frame into the desired location with the
3/8” tabs facing the inside of the wall.
5. Place the other 25” horizontal bar onto the top of the
cut-out frame and nail or screw it into the studs.
6. Flatten the outer edge of the slot of the mounting
bars against the with a hammer studs to keep the frame
from sliding.
7. Once the drywall has been hung, use keyhole or similar
saw to cut out the hole to the inside edge of the cut-out
frame.
8. Install the Custom Series loudspeaker as shown above in
Installing in Existing Walls and Ceilings. Make sure
the Custom Series mounting bracket is installed on the
speaker with the slotted side facing toward you and the
flat side facing away from you. This allows the upper and
lower sections of the mounting bracket to fit into the upper
and lower tabs of the cut-out frame.
Flatten Here
Flatten Here