CONTROLS/OPERATION
Your fireplace has the following functions:
FOR YOUR SAFETY
Repairs must be performed by a qualified person.
REPLACING THE LIGHT BULBS
This fireplace uses 2 clear 110 Volt, 40 Watt, E-12 socket base light bulbs (small base,
chandelier candle type bulb). The access plate is located on the back of the unit. For
convenience, if one of the light bulbs burns out, it may be easier to replace both of the
light bulbs at the same time.
WARNING
: Do not exceed 40 Watts per bulb. Use of higher a rated bulb may result in a
fire, causing property damage, personal injury or loss of life.
1. Turn off the power to the unit, and unplug it from the electrical outlet.
2. Let the fireplace cool if it has been operating.
3. Turn the fireplace so you are facing the back of the fireplace.
4. Look for the access plate with the gold printing on it.
5. Remove the 2 screws holding the access plate in position (FIG1). Once you have
removed the 2 screws, lift the access plate so the 2 positioning tabs come free of
their slots. Once you have removed the access plate you can see and access the
40 watt chandelier bulb (FIG 2).
FIG 1
FIG 2
Low heat II
700 watts
On/Off I / O
Power to the unit
High heat III
1400 watts
Note:
For a high level of
heat press “II” and “III”
-4-
BULB COVER
Temperature Adjustment
Dimming Adjustment
The control switches are on the back of the unit.
1.
Plug the appliance into the socket and press “ I ” to turn on
2.
Adjust the dimming knob for the desired flame effect.
3.
For a low level of heat press “ II ”
4.
For a high level of heat press “II” and “III”
Adjust the thermostat control knob to regulate the heat.
Dimming
Intensité
