HEATER ASSEMBLY
STEP 1:
Locate the Tank Housing Assembly (1). Open the front panel and remove the
cartons containing all parts needed for assembly of the appliance.
PREPARATION FOR ASSEMBLY
Before beginning assembly of this appliance, make sure all parts are present. Compare
all parts with Parts List as shown on page 6 of this manual. If any part is missing or
damaged, do not attempt to assemble this product. Contact customer service for
replacement parts. Assembly should be performed on a flat, level, non-abrasive
surface.
ESTIMATED ASSEMBLY TIME: 45 minutes
Tools Required for Assembly (NOT included):
Philips Head Screwdriver
Leak Detection Solution
STEP 2:
Locate the Stability Ring (2). Fit the Stability Ring (2) onto the bottom of the
inside of the Tank Housing Assembly (1) and attach with 3 bolts and nuts provided in
the bag with the Stability Ring.
STEP 3:
Locate the Wheel Kit with Hardware (3). Loosen and remove the nuts and bolts
(4 nuts/bolts on each wheel) that come already assembled to the wheels. Locate the
brackets on the rear bottom legs of the Tank Housing Assembly (1) (Fig. A). Align
wheels with the holes in brackets. Before you attach the wheels to the brackets, the
wheel should sit flat on the ground (Fig. B). Attach the wheels to the brackets using the
nuts and bolts that you have loosened and removed from the wheels. Once you
attach the wheels, the wheels should now sit slightly above the ground (Fig. C) as
wheels should only engage for moving heater when the heater is tipped backwards
slightly—if wheels are flat on the ground once attached to the brackets with heater in
UPRIGHT position, then wheels are NOT correctly mounted on the brackets.
- 7 -
Summary of Contents for PH08-S BK
Page 9: ......
