Page 11
5HPRWH&RQWURO6SHFL¿FDWLRQV
Storage Instructions
1. MCU Chips: SN8
F570320
Chip
2.
6RIWZDUH/5&
12
4
3. Remote: 1
1
key remote
4.
NOTE: Make sure your “AA” batteries (x2) are
fully charged and installed correctly in your
remote control before operating.
The remote control must remain within 6
meters or 20 feet of the appliance to be
effective, this range may be reduced when
battery power is depleted.
Maintenence
PREPARATION FOR MAINTENANCE
ALWAYS DISCONNECT THE POWER AND ALLOW THE ELECTRIC APPLIANCE TO COOL BEFORE
PERFORMING ANY CLEANING, MAINTENANCE OR RELOCATION OF THIS ELECTRIC APPLIANCE.
TURN CONTROLS TO OFF AND REMOVE PLUG FROM OUTLET OR TURN OFF THE HOUSE
CIRCUIT BREAKER TO ELECTRIC APPLIANCE RECEPTACLE.
DO NOT INSTALL REPLACEMENT BULBS THAT EXCEED SPECIFIED MAXIMUM WATTS.
THE BULBS IN YOUR APPLIANCE CAN BECOME EXTREMELY HOT. ALLOW AT LEAST
10 MINUTES BETWEEN TURNING OFF THE APPLIANCE AND REMOVING THE LAMPS TO AVOID
ACCIDENTAL BURNS.
DO NOT HANDLE THE BULBS WITH BARE FINGERS, OILS FROM YOUR SKIN WILL DAMAGE THE
BULS WHEN THEY HEAT UP. USE GLOVES OR A CLEAN DRY CLOTH WHEN HANDLING BULBS.
WARNING
Ensure the power cord is not installed so that it is pinched or against a sharp edge and ensure that the
SRZHUFRUGLVVWRUHGRUVHFXUHGWRDYRLGWULSSLQJRUVQDJJLQJWRUHGXFHWKHULVNRI¿UHHOHFWULFVKRFNRU
injury to persons.
Construction and electrical outlet wiring must comply with local building codes and other applicable
UHJXODWLRQVWRUHGXFHWKHULVNRI¿UHHOHFWULFDOVKRFNDQGLQMXU\WRSHUVRQV
'RQRWDWWHPSWWRZLUH\RXURZQQHZRXWOHWVRUFLUFXLWV7RUHGXFHWKHULVNRI¿UHHOHFWULFVKRFNRULQMXU\WR
persons, always use a licensed electrician.
05.28.19
Item No.
: EF-130P
