STEP 8 : OPERATION & STORAGE
8 -1 OPERATION
Ignition
1. Open the LP gas cylinder valve at the propane tank.
1a. Align symbols on control knob with calibration mark (see illustration).
2. Turn control knob to a position half way between small flame (8b) and the
large flame symbol (8c) aligning with calibration mark. Depress control knob
and then push electronic ignitor button to ignite the main burner. Repeat until
main burner ignites.
3. Keep the control knob fully depressed for an additional 30 seconds after
burner ignites. If burner does not stay lit, repeat above operation.
NOTE : Main burner may also be lit using a MATCH
CAUTION:
Be aware of gas build-up when lighting with match-especially after
holding down control knob. If you smell gas, WAIT 5 minutes for gas to dissi-
pate before ligthing.
Normal Operation
After main burner is ignited, turn control knob to either low position (small
flame symbol – see fig. 8b) or high position (large flame symbol – see fig. 8c).
To turn OFF appliance : turn to OFF symbol (see fig. 8a)
•
Note : after turning off the unit, wait 5 minutes before attempting to relight.
Completely shut off/close LP gas cylinder valve.
•
Manual Lighting
: place a match thru any of the large holes at the bottom of
the burner unit while following the lighting procedures above.
Shutdown
Turn control knob to OFF symbol, small white dot (fig. 8a).
Electric Ignitor – Battery Replacement
Requires 1-AAA battery – alkaline type recommended. Unscrew rubber/vinyl
housing. Replace battery – negative (flat) end of battery facing out. Gently
reattach housing by threading into place.
WARNING : Read the installation, operation, and maintenance instructions thor-
oughly. BEFORE operating, installing or servicing this equipment, improper use,
adjustment, service and/or maintenance can cause serious injury or damage to
your property.
Minimum Clearance to adjacent combustible surfaces is as follows :
Sides – 24’’ Top – 36’’
The Gas Supply Must be turned OFF at the LP Gas Cylinder when this
appliance is not in use.
OPERATION & STORAGE - 11
** Think Safety**
After appliance shuts
down Do NOT touch or
move unit for at least
30 minutes. This allows
proper cooling of the
heater components.
** NOTICE **
During the FIRST TIME use
only. It is normal to expe-
rience a small amount of
smoke coming from the re-
flector hood. This is due to
the burn off the protective
coating applied during the
manufacturing process.
