Page 16
Main Power Switch
Operating with Touch Panel
Once the appliance has been plugged into a grounded electrical outlet, it is ready to operate.
NOTE: Ensure the house circuit breakers for the power supply are turned on. In the event of a power
failure, the appliance will lose its memory function and will reset to factory mode when the power
returns.
To turn unit power on:
1. Plug in power cord.
2. Turn on the power switch (located on the front bottom right side of the appliance).
3. Verify the power is turned on when two ring tones are initiated.
The unit can be controlled by either the touch panel controls which are located on the right side of the front
glass or the remote control.
1.
Operating Instructions
WHILE THE APPLIANCE IS OPERATING DO NOT REMOVE THE GLASS PANEL. THIS WILL CAUSE THE
REMOTE CONTROL AND TOUCH PANEL TO DISFUNCTION.
WARNING
ON/OFF
Power
Flame
Timer
Heater
Indicator
03.16.21
: Press power on/off button. Fireplace is turned on. LED displays " ".
: Heater is .Flame at the brightest level ( )with red/blue/yellow flame on. Backlight is
on with red/blue/yellow flame on. Backlight is on with red/yellow/ blue combination ( ). Ember bed color
: Press button multiple times to cycle through 4 different brightness levels
1.
2.
and OFF for all the flame color options(Red, Yellow, Blue), display
: Press " " multiple times to set the operating duration to 30 min, 1h, 2h, 3h, 4h, 5h, 6h, 7h,
3.
8h, 00(timer off) respectively.
: Press " " key: set the required room temperature. The parameters is pre-set
4.
in degrees Celsius16-19-21-23-25-27-30-OFF (indicate H0) as a repeat circulation.
Press key for 5 seconds, then a single "beep" sound will be heard which indicates the temperature switches
to Fahrenheit degree. The parameter is set to Fahrenheit degree of 61-66-70-73-77-80-86-OFF (indicate )
as a repeat circulation.
is white( ).
Fireplaces ON and OFF
ON
Initial setting
OFF
F4
C3
C3
Flame Brightness adjustment
F4-F3, F2, F1,FO.
Timer function
Heater temperature setting
HO