Paramount Fitness FPT1880, Instructions And Owner'S Manual

Page: 11 / 19

11
OPERATING INSTRUCTIONS
CAUTION
Do not attempt to operate until you
have read and understand all General
Safety Information in this manual and
all assembly is complete and leak
test has been performed.
BEFORE TURNING GAS SUPPLY ON:
Your appliance was designed and
approved for outdoor use only.
Do NOT use it inside a building, garage, or any other enclosed area.
2. Make sure surrounding areas are free of combustible materials, gasoline, and
3. Ensure that there is no obstruction to air ventilation. Be sure all gas connections
are tight and there are no leaks.
4. Be sure the cylinder is clear of debris. Be sure any component removed during
assembly or servicing is replaced and fastened prior to starting.
1.
2.
BEFORE LIGHTING:
The appliance should be thoroughly inspected before each use, and by
>¿ªÉ>ŠƒÚg_¿¸gµÐƒUg¿¡gµ¸”¿>Á¿Šg>¸Á¿>É>ŠŠÓ¦¿
If relighting a hot appliance, always wait 5 minutes with tank valve closed.
Inspect the hose assembly for evidence of excessive abrasion, cuts, or wear. Suspected areas should be leak tested. If the
hose leaks, it must be replaced prior to operation. Only use the replacement hose assembly
¸¡gUƒÚg_¿L y manufacturer.
DANGER!
FOR OUTDOOR USE ONLY
CARBON MONOXIDE HAZARD
Never use this inside a house, or other
unventilated or enclosed areas. This appliance
consumes air (oxygen). Do not use in
unventilated or enclosed areas to avoid
endangering your life.
WHEN FIRE PIT IS ON:
Burner will display tongues of blue and
not be yellow or produce thick black
smoke, indicating an obstruction of
should be blue with straight yellow
tops. If excessive yellow
Û>g¿ƒ¸
detected, turn off Úµg¿¡ƒÁ¿>_¿U”¸ÉŠ t
the “Troubleshooting” section near the
end of this manual.
LIGHTING:
1. Turn the control knob to “OFF” position. (Figure A)
2. (Natrural Gas skip to Step 3) Fully open LP cylinder valve. Note: For initial start or after any cylinder change, hold
Control Knob IN for 2 minutes to purge air from gas lines before proceeding.
3. Push in gas control knob and turn counterclockwise to “HIGH” (Figure B). Press igniter button. If needed, return gas control
knob to “OFF” and repeat these steps until Ág¿Úµg¿¡ƒÁ¿Šƒy hts (you should hear a clicking sound each time).
4. After the appliance lights, release control knob If you want a lower temperature push in the control knob and turn .
counterclockwise to the “LOW” Position (Figure C).
NOTE: If burner fails to remain lit, close all valves and wait at least 5 minutes for accumulated gas to dissipate before
attempting to light.
OPERATING INSTRUCTIONS
WARNING
Very hot while in operation!
Do not touch Table Top or Burner
after use before placing Lid on Table Top
or touching any surfaces. Failure to comply
with these instructions may result in
serious bodily injury.
a
Electronic igniter
requires AAA battery
Standard igniter,
no battery required
NOTE ： Some models have an Electronic
Igniter and will require installation of 1-AAA
battery.The battery should be installed by
unscrewing the RED IGNITER BUTTON.
Standard igniter,
b
C e r u g i F
Figure A Figure B
Contact us for assistance: customercare@jrhome.com | (800) 561- 5550