ASSEMBLY INSTRUCTIONS
5
1. Locate 2 side trim pieces (A)
and 1 top trim piece (B). Align slotted
holes in trim pieces with holes on tops and
sides of insert (C). See Fig. 2
Attach trim pieces to electric insert (C)
using 4 screws (AA) per piece of trim.
Tighten using a Phillips screwdriver.
CONTROL PANEL / FUNCTIONS
OPERATING INSTRUCTIONS
LOCATION
POWER /ON/OFF BUTTON
Push the power button once (indicator light will come on) to supply power for all of the functions.
Push button once to turn all functions off.
FLAME INTENSITY
HEAT SETTINGS
TIMER
Push the flame + or - button for desired flame
This fireplace insert consists of a fan forced electric heater with two heat settings, 750 watts or 1,500
watts. For low heat, push the temperature button once (indicator light will illuminate). For high heat,
push the temperature button a second time (indicator light will illuminate).
Note: the fan may con-
tinue to run for a short time after the heat is turned off. The fan will turn off automatically.
This electric fireplace is equipped with a timer ranging from 1/2 hour to 7 1/2 hrs. Press the timer
button to the desired time (indicator lights will illuminate). Push button once for every 1/2 hour
increment. Do not leave heater unattended.
Control Panel
Master Power Button
The Master Power Button is located in the lower right hand corner of the front insert. The control
panel is located in the lower left corner of the front of the insert. Open the doo
r to access.
Fig. 2
B
A
C
AA
Hardware Used
AA
Screws
X 12
