5
PRE-PLASTER DETAIL | SMOOTH BODY INSTALLATION
1. Make a cutout or opening approximately 1"
deep and 1" bigger than the pipe. This cutout
will be filled with plaster or other finish coat to
create a water stop.
2. Cut off riser pipes flush with concrete
surface.
3. Remove cap. Prime the inside of the pipe.
DO NOT PRIME THE BODY.
4. Glue the body into the pipe with a regular
PVC glue.
The glue must cover the full length of the body
barrel and 3” deep inside the riser pipe. Push
the body into the pipe until the shoulder hits the
top edge of the pipe.
Let fumes vent for 30 minutes then replace all
body caps.
5. PLASTERING THE POOL
Leave all plaster caps in place for removal at
start up.
NOTE: Optional, the plaster crew may remove
the plaster caps as they finish.
NOTE: The body does not come with the
nozzle installed.
NOTICE: You can use regular PVC glue on smooth body
SOIL
CONCRETE
