Copyright © Parallax, Inc. • PING))) Bracket Kit (#570-28015) • v1.1 8/10/2007 Page 3 of 4
Step 6:
Attach the PING))) Mounting Bracket and
servo to the straight brackets using (4)
4/40 screws and (4) 4/40 nuts. Replace the
servo’s shaft screw once the PING)))
Mounting Bracket is installed.
Important: Before using the servo
screw, adjust the Ping))) bracket to
rotate 90
°
left and right.
Step 7:
Set the Servo Port Jumper on the Board of
Education to Vdd, then plug the servo into
servo port 14.
Note: If your board has no servo ports, or
no servo port jumper, or if you want to
keep the servos connected to Vin instead of
Vdd, follow the Breadboard Connection
section on page 3.
Step 8:
Connect the servo extension cable to the
PING))) sensor: Black to GND, Red to 5 V,
and White to SIG.
Plug the other end of the Ping))) sensor’s
cable into servo port 15.
You can download sample BASIC Stamp 2 source code and videos of
the Boe-Bot robot autonomously roaming with the Ping))) sensor
from the 570-28015 product page at
www.parallax.com
