Paradyne T1 Access Mux 916x, Technical Reference

Page: 115 / 326

Setting Up
5-61
9161-A2-GH30-30 April 1998
Setting Up to Support a Telnet or FTP Session
Use the Telnet/FTP Session Options screen to allow a Telnet or FTP session
through an interconnected IP network. These options also set up security for the
Telnet or FTP session (see Table 5-12). Only one Telnet session can be active at
any one time.
Procedure
1. Set the Node IP Address, Node Subnet Mask, Default Network Destination,
and the Communication Protocol Port Link (see Table 5-14 ). Follow this menu
selection sequence:
Configuration Edit/Display
→
Management and
Communication
→
Communication Protocol
2. Set the Telnet/FTP configuration options (see Table 5-12 ). Follow this menu
selection sequence:
Configuration Edit/Display
→
User Interface
→
Telnet Session
3. The Telnet/FTP Session Options screen appears. Enter the desired setting in
each selected field.
4. Set the Port Use configuration option to Net Link (see Table 5-10 ). Follow this
menu selection sequence:
Configuration Edit/Display
→
User Interface
→
Communication Port
Or, set the Management Link configuration option to FDL or DDL, and set the
IP address (see
Table 5-12 ). Follow this menu selection sequence:
Configuration Edit/Display
→
Network Interface Options
Or, set the Embedded Data Link configuration option to Enable for the
Synchronous Data Port, and set the IP address (see
Table 5-3 ). Follow this
menu selection sequence:
Configuration Edit/Display
→
Synchronous Data Port Options