MIM4-A2-GZ42-00
June 2005
3
Unpacking and Inspecting the Equipment
HANDLING PRECAUTIONS FOR
STATIC-SENSITIVE DEVICES
This product is designed to protect sensitive components from damage
due to electrostatic discharge (ESD) during normal operation. When
performing installation procedures, however, take proper static control
precautions to prevent damage to equipment. If you are not sure of the
proper static control precautions, contact your nearest sales or service
representative.
If there is any visible damage, do not attempt to install the MIM-4E1; contact your
sales representative.
Installing the MIM-4E1
The MIM-4E1 Micro Interface Module provides additional uplink ports for the
4929 DSLAM or BSX8000-5 Broadband Services Switch.
NOTE: All MIMs are hot swappable, although removal of a MIM disengages the
upstream network connection for the DSLAM.
Procedure
1. Using a flat-head screwdriver to loosen the fastening screws, remove the
cover plate from the MIM port on the front of your 4929 or BSX8000.
CAUTION: The cover plate should be stored for possible future use: if the MIM
is removed from your 4929 or BSX-8000, it must be replaced with either
another MIM or a cover plate. Do not operate a 4929 or BSX8000 with an
open MIM port.
2. Align the MIM-4E1 with the module guides inside the MIM port.
3. Slide the MIM-4E1 firmly into place. Do not use excessive force.
4. Secure the MIM-4E1 by tightening the fastening screws on the MIM faceplate
with a flat-head screwdriver.
!
MIM-4T1/E1
05-17671
Lnk/Alm 1 Act Lnk/Alm 2 Act Lnk/Alm 3 Act Lnk/Alm 4 Act
